HVAC Installation in Fort Thomas, KY
A new system here will heat from October through April and cool from June through September every year. Tell us about the house, and a licensed contractor who covers Campbell County will get in touch.
Tell us about the job
It takes about a minute.
What Fort Thomas asks of a new system
Eleven months out of the year, your house is either heating or cooling. Winter nights average 26°F from December through February, so a new furnace or heat pump has to hold steady on the cold nights, not just the mild ones. Summer afternoons average 85°F, and the system you install now needs to handle four straight months of that, June through September.
A new system installed here should be sized for both jobs, not just whichever one is on your mind today. Almost half of homes in this area heat with gas, so if you're replacing a furnace, matching it to the right air conditioner or heat pump matters as much as the furnace itself. And with 13 winter storms and 43 damaging wind events recorded here over the past ten years, it's worth asking your contractor how the new equipment holds up when the power blinks or a line goes down.
- 7 months
- October through April, your system heats
- 4 months
- June through September, it cools
- 26°F
- the average winter night it heats against
- 85°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Kentucky requires HVAC contractors to hold a state license.
The state license is issued to the contractor by the Department of Housing, Buildings and Construction, not to any single job. It tells you the contractor was tested and is on record with the state before they ever set foot in your house.
For an installation like this one, that license is what stands behind the person doing the work, but the job itself gets a second check. In most cities and counties in Kentucky, putting in a new heating and cooling system needs a permit from the local building office, and the work gets inspected once it's done. That inspection is where the gas connections, the wiring and the refrigerant lines get looked at by someone besides the installer.
Sources: Kentucky Legislative Research Commission · Kentucky Department of Housing, Buildings and Construction
- When should I replace my HVAC system?
- Once repairs are getting expensive and frequent, or your furnace or air conditioner is old enough that you are wondering rather than sure it will start, that is the point to plan a replacement instead of waiting for the next breakdown. In Fort Thomas that timing matters more than it would somewhere milder. Your furnace is working seven months a year here, October through April, with winter nights averaging 26°F, so a failure during that stretch is not something you want to ride out. Watch for rising bills, rooms that heat or cool unevenly, and a system that runs longer than it used to. If your furnace is struggling, have it looked at before the cold months start, not after.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, replacing them together usually makes sense, but it comes down to the condition of each one. A furnace and air conditioner installed at different times can still run fine together as long as they are matched correctly. Here, your furnace carries the load seven months a year and your air conditioner four, so the furnace usually wears first. If yours is near the end of its life while the air conditioner still has years in it, a contractor can tell you whether replacing just the furnace now makes sense, or whether doing both together is the better move for your house.
- What happens during an HVAC installation?
- A contractor removes the old furnace and air conditioner, sets the new equipment in place, and connects it to your ductwork, gas line or electrical circuit, refrigerant lines, and thermostat. They test the system to confirm it heats, cools, and cycles the way it should before calling the job done. In most Fort Thomas area cities and counties, this work needs a permit from the local building office along with an inspection once installation is finished, to confirm the work meets code. It is worth asking your contractor how they handle the permit and scheduling that inspection.