Furnace Installation in Georgetown, KY
A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Scott County will get in touch.
Tell us about the job
It takes about a minute.
Georgetown asks a lot of a furnace
Winter nights here average 26°F, and homes need heat from October through April, seven months of the year. That is most of the year spent leaning on a furnace to keep a house warm, not just a handful of cold snaps.
Most homes here heat with electricity, and the power does not always stay on. Kentucky saw 24 percent of households lose power for at least 24 hours in 2024, and this area has logged 11 winter storms and 65 damaging wind events over the past ten years. A new gas furnace installed today has to meet a federal minimum of 80 percent AFUE, so whatever goes in should be sized and installed to hold up through a long heating season and whatever weather comes with it.
- 7 months
- October through April, your furnace is on duty
- 26°F
- the average winter night it heats against
- 80% AFUE
- the federal minimum any new unit must meet
NOAA nClimDiv, 1991–2020 normals
Kentucky requires HVAC contractors to hold a state license.
Kentucky's license is issued through the Department of Housing, Buildings and Construction. It covers the contractor as a business, not the furnace going into your house, so the license tells you the state tested this contractor and keeps a record of them, not that it signed off on this particular installation.
For a furnace installation in Scott County, that record is what stands behind the contractor. The part that checks the work itself is the local building office. Most cities and counties require a permit for a furnace replacement and an inspection once it is done, and that inspection is what looks at the gas connections and venting on this job.
Sources: Kentucky Legislative Research Commission · Kentucky Department of Housing, Buildings and Construction
- What size furnace does my house need?
- There's no single number that fits every house. It depends on square footage, ceiling height, how much insulation is in the walls and attic, how many windows you have and which way they face, and how airtight the place is. A furnace that's too big will short cycle, turning on and off fast without running long enough to heat evenly. One that's too small will run constantly on the 26°F nights here and still fall behind. A contractor sizes it with a load calculation based on your specific house, not a chart based on square footage alone.
- How do I know it's time to replace my furnace?
- Watch for uneven heat between rooms, a furnace that's cycling more than it used to, or a jump in what you're paying to run it. Breakdowns that come more than once a season are another sign, especially with a furnace that has to run October through April here, seven months of the year. A contractor can look at the unit's condition and tell you honestly whether another repair makes sense or whether it's time to replace it.
- Is a high-efficiency furnace worth it?
- Every non-weatherized gas furnace made since November 2015 has to reach at least 80 percent AFUE, so even a standard model isn't wasteful. A high-efficiency furnace pushes that number higher, meaning less of the gas you burn goes up the flue instead of into your house. With winter lows averaging 26°F and heat needed seven months of the year here, that furnace is doing real work most months. Whether the higher upfront cost pays off for your house depends on its heat loss and how you use it, and a contractor can walk through that with you directly.