Water Heater Repair in Georgetown, KY
Tell us what your water heater is doing, and a licensed contractor who covers Scott County will get in touch.
Tell us about the job
It takes about a minute.
Georgetown winters put your water heater to work
Your water heater runs harder from October through April, when the water coming into the tank is colder and the burner or element has to work longer to catch up. On nights that average 26°F, a tank that struggles will show it fast, with lukewarm water or a shorter supply of hot water than you're used to.
Georgetown also loses power sometimes. Statewide, close to a quarter of households went at least a day without power in 2024, and Scott County has seen its share of winter storms and high wind over the past ten years. A gas water heater with a standing pilot will keep working through an outage. One with electric ignition or an electric tank will not come back on until the power does, and most units restart on their own once it's back.
- 26°F
- the average winter night, and colder incoming water means longer heating
- 7 months
- October through April, the months homes here need heat
- 24%
- of Kentucky households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it
NOAA nClimDiv, 1991–2020 normals
A new water heater would cut about $270 a year off hot water for a typical Kentucky home.
Estimates for a typical Kentucky home, compared with an older unit built to the federal minimum, from EIA household energy data and Kentucky fuel prices. Your home will differ.
Repair makes sense when an element, thermostat or gas valve has failed.
Replacement makes sense when the tank itself is leaking.
- Why is my water heater leaking from the bottom?
- Most often the tank itself has rusted through and is failing from the inside. Water heaters have a steel tank with a glass lining, and once that lining cracks, the steel underneath corrodes and eventually lets water through. A leak from the bottom can also come from the drain valve or from fittings that have loosened over time, so it is worth checking those before assuming the tank is done. If the tank itself is leaking, it needs to be replaced, not repaired, since there is no way to seal a corroded tank.
- Why won't the pilot light on my water heater stay lit?
- The most common cause is a worn thermocouple, the small sensor that sits in the pilot flame and tells the gas valve it is safe to keep the gas flowing. When it wears out, it fails to sense the flame properly and shuts the gas off, even though the pilot lit fine a moment ago. A dirty pilot orifice or a draft in the area can also blow the flame out or keep it too weak to register. A licensed contractor can test the thermocouple and replace it if that is the problem, since it is not a part most people have on hand.
- Can a tankless water heater be repaired?
- Yes, most problems with a tankless water heater are repairable. Error codes usually point to something specific, like a flow sensor, an igniter, or buildup on the heat exchanger, and a contractor can diagnose which one it is. Tankless units also depend on venting and water flow being right, so sometimes the fix is clearing a blocked vent or descaling the unit rather than replacing a part. A contractor licensed in Kentucky can look at the specific unit and tell you what is failing and whether it makes sense to repair it or replace it.