HVAC Repair in Elizabethtown, KY
Homes here need heat from October through April and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Hardin County will get in touch.
Tell us about the job
It takes about a minute.
Your system works all year in Hardin County
There is no real break here. Heat runs October through April, then cooling takes over for May through September. That is twelve months of a furnace or an AC unit doing its job, with almost no downtime to notice small problems before they become big ones.
Winter nights averaging 27°F mean the furnace cycles on and off for hours at a stretch, and each start puts wear on the igniter. Summer afternoons near 86°F push the air conditioner's compressor hard for months, not weeks. Most homes here heat with electricity, so when a storm knocks out power, heat stops too. Hardin County has seen 17 winter storms and 74 damaging wind events over the past ten years, and statewide, almost a quarter of households lost power for a full day or more in 2024. When the power comes back, most systems restart on their own. If yours does not, that is worth a call.
- 7 months
- October through April, your system heats
- 5 months
- May through September, it cools
- 27°F
- the average winter night it heats against
- 86°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Kentucky requires HVAC contractors to hold a state license.
The license comes from the Department of Housing, Buildings and Construction, which tests contractors before it lets them hold one and keeps a record of who does. It is issued to the contractor, not to any one job, so the same license is what stands behind every repair that contractor takes on.
For a heating and cooling repair, that license is what you're relying on. It tells you the contractor doing your repair has been tested and is on record with the state, not just that the business exists.
Sources: Kentucky Legislative Research Commission · Kentucky Department of Housing, Buildings and Construction
- Why is my heat not working?
- Most often the thermostat is calling but something in the ignition or power chain is not answering. On a gas furnace, check that the igniter is glowing or listen for a click and a whoosh when it starts. If neither happens, the flame sensor or igniter itself may have failed. If your home heats with electric heat, a tripped breaker or a bad heating element can leave you with cold air blowing or no air at all. With lows averaging 27°F here in the winter, a furnace that will not stay lit is worth getting looked at the same day, not the next one.
- Why is my system running but not cooling the house?
- The blower is moving air but something is stopping that air from actually being cold. A dirty filter is the first thing to check, since it chokes airflow across the coil and can freeze it up entirely. If the filter is clean, low refrigerant from a leak is a common cause, and that is not something you can add yourself, it has to be diagnosed and sealed. A failing outdoor unit, the part with the fan and compressor, will also leave you with warm air moving through the vents. On an 86°F afternoon this isn't just uncomfortable, it means the system is running constantly without doing its job, which is worth calling about before it strains anything further.
- What can I check before calling for HVAC repair?
- Start with the thermostat. Make sure it's set to heat or cool as needed and that the batteries aren't dead. Next, check the filter and replace it if it's gray or clogged, since restricted airflow causes more heating and cooling complaints than almost anything else. Check your breaker panel for a tripped switch, especially after a storm. Kentucky sees its share of wind and winter storms, and a chunk of households here lose power for a day or more some years, so a reset breaker after an outage is worth checking before anything else. If the system still won't run right after these checks, a licensed contractor can diagnose what's actually wrong.