HVAC Installation in Madisonville, KY
A new system here will heat from October through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Hopkins County will get in touch.
Tell us about the job
It takes about a minute.
A system that runs almost every month of the year
In Madisonville, heat runs October through April and the air conditioner picks up May through September. Between the two, some system in the house is working 12 months a year.
Winter nights average 29°F here, cold enough that a furnace or heat pump runs most nights it comes on. Summer afternoons average 87°F, so the cooling side carries real load too. Close to half of homes here heat with electricity, which makes the efficiency of the system you choose part of what you pay each month. Hopkins County has also seen 13 winter storms and 68 damaging wind events over the past ten years, and in 2024 nearly a quarter of Kentucky households lost power for at least a day. Whatever gets installed should be able to come back on by itself and heat or cool the house without anyone home to reset it.
- 7 months
- October through April, your system heats
- 5 months
- May through September, it cools
- 29°F
- the average winter night it heats against
- 87°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Kentucky requires HVAC contractors to hold a state license.
The state license comes from the Department of Housing, Buildings and Construction, and it covers the contractor, not each job. That contractor is tested and on record with the state before they ever set foot in a home.
For a heating and cooling installation in Hopkins County, that license is what makes the contractor accountable for the work. The installation itself also runs through the local building office. Most cities and counties in Kentucky require a permit before a furnace or air conditioner goes in, and an inspection once the work is done. The permit and inspection cover whether the new system was put in to code, separate from what the state license covers.
Sources: Kentucky Legislative Research Commission · Kentucky Department of Housing, Buildings and Construction
- When should I replace my HVAC system?
- Once your system is breaking down more than once a season, or a contractor tells you the compressor or heat exchanger is failing, replacement is worth looking at over another repair. An aging furnace or air conditioner has to work harder to keep up, and homes here need heat or cooling every month of the year, October through April for heat and May through September for cooling. If your energy bills keep climbing while the equipment gets less reliable, that combination points to replacement rather than another repair.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, replacing them together makes sense, since a furnace and air conditioner are often matched to work as a system and a mismatched pair can run less efficiently. It's not required. Plenty of homeowners replace just the failed unit and keep the other running until it needs attention. A contractor can look at the age and condition of both and tell you whether pairing them makes sense for your house.
- What happens during an HVAC installation?
- A contractor removes the old furnace, air conditioner or heat pump and sets the new equipment in its place, connecting it to the ductwork, electrical, and for gas furnaces, the gas line. They check refrigerant lines on an air conditioner or heat pump, then test the system to confirm it heats and cools correctly once it's running. In most cities and counties here, this job needs a permit from the local building office, and an inspector checks the work when it's done.